page_banner

Products

COC,OPI,MDMA,AMP,THC,BZO One Step Drug Test Test Device Saliva


Short Description:

The Drug Test Test Device Saliva is a lateral flow chromatographic immunoassay for the detection of Drug Test in human Saliva. This test will detect other compounds, please refer to Analytical Specificity table in this package insert.


  • Drug Test Saliva: COC,OPI,MDMA,AMP,THC,BZO One Step Drug Test Test Device Saliva
  • :

    Product Detail

    Product Tags

    INTENDED USE

    During testing, a urine specimen migrates upward by capillary action. Drug Test, if present in the urine specimen below 300 ng/mL, will not saturate the binding sites of the antibody coated
    particles in the test device. The antibody coated particles will then be captured by immobilized
    Drug Test conjugate and a visible colored line will show up in the test line region. The colored line will not form in the test line region if the Drug Test level is at or above 300 ng/mL because it will saturate all the binding sites of anti-Drug Test antibodies.
    A drug-positive urine specimen will not generate a colored line in the test line region because of drug competition, while a drug-negative urine specimen or a specimen containing a drug
    concentration less than the cut-off will generate a line in the test line region. To serve as a
    procedural control, a colored line will always appear at the control line region indicating that
    proper volume of specimen has been added and membrane wicking has occurred.

    KIT COMPONENTS(Device)

    Individually packed Test Devices
    Each device contains a strip with colored conjugates and reactive reagents pre-spreaded at the corresponding regions.
    Disposable pipettes
    For adding specimens use.
    Package insert
    For operation instruction.

    PROCEDURE

    Controls to room temperature (15-30°C) before Bring tests, specimens.
    1. Bring the pouch to room temperature(15-30°C) before opening it. Remove the test device from the sealed pouch and use it as soon as possible.
    2. Place the test device on a clean and level surface. Hold the dropper vertically and transfer 3 full drops of urine (approx. 100 µL) to the specimen well (S) of the test device, and then start the timer. Avoid trapping air bubbles in the specimen well (S).
    3. Wait for the colored line(s) to appear. Read results at 5 minutes. Don’t interpret the result
    after 10 minutes.

    INTERPRETATION OF RESULTS

    1

    Only one colored band appears in the control region (C).

    No apparent colored band appears in the test region (T).

    2

    Two colored bands appear on the membrane. One band

    appears in the control region (C) and another band

    appears in the test region (T).

    3

    Control band fails to appear. Results from any test which has not produced a control band at the specified readingtime must be disgarded. Please review the procedure andrepeat with a new test. If the problem persists, discontinue using the kit immediately and contact your local distributor.

    NOTE

    1. The intensity of the color in test region (T) may vary depending on the concentration of
    aimed substances present in the specimen. Therefore, any shade of color in the test region
    should be considered negative. Besides, the concentration level can not be determined by
    this qualitative test.
    2. Insufficient specimen volume, incorrect operation procedure, or performing expired tests
    are the most likely reasons for control band failure.


  • Previous:
  • Next:


  • Previous:
  • Next: